Welcome to Our Community

Some features disabled for guests. Register Today.

Openbuilds interface gets stuck sending job.

Discussion in 'Interfaces' started by Ethan Maloy, May 23, 2024.

  1. Ethan Maloy

    Builder

    Joined:
    Oct 17, 2022
    Messages:
    28
    Likes Received:
    3
    I got my interface set up today to run a job so that my laptop would not be tied up for 6 hours on the job. After some issues with the naming system and learning has the interface does not like having folders within I was able to open my g-code files and click run, from there the interface gets stuck “sending” and does not run the job.

    I can run the job from the control software on my laptop, but I have noticed that when I reinstalled the software on his computer, I have the issue that when I lot run the CNC does not run right away, I have no pause and resume job. After hitting resume job the machine runs without issue.

    I assume these two issues are connected, however I do not know how no fix them. Any help is appreciated!

    Machine: Lead 1515
    Controller: x32
    Firmware: 1.58 (latest available as of this morning)
    Control Software: 1.0.374
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,010
    Likes Received:
    4,304
  3. David the swarfer

    David the swarfer OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Aug 6, 2013
    Messages:
    3,447
    Likes Received:
    1,912
    please upload your Gcode file so we can check it
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice