Welcome to Our Community

Some features disabled for guests. Register Today.

Vacuum laser table

Discussion in 'Laser Cutters' started by Cody Kesler, Jun 16, 2019.

  1. Cody Kesler

    Builder

    Joined:
    May 31, 2019
    Messages:
    1
    Likes Received:
    4
    Cody Kesler published a new build:

    Read more about this build...
     
  2. GrayUK

    GrayUK Openbuilds Team Elder
    Staff Member Moderator Builder

    Joined:
    May 5, 2014
    Messages:
    1,668
    Likes Received:
    627
    Cool looking build. :thumbsup:
    I wonder if the vacuum will deal with, the smoke and burn smells created by the laser/plasma, as well as the hold-down properties? :rolleyes:
     
  3. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,758
    Likes Received:
    2,438
    Hi @Cody Kesler Great to see you here sharing your build on OpenBuilds! Thank you.
    So for setting up your machine size you only need to set the OpenBuilds CONTROL software to custom machine type and then you can set up the parameters like bed size there for your machine.
    Hope this helps, all the best with your build my friend. :thumbsup:
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice