Welcome to Our Community

Some features disabled for guests. Register Today.

Workbee 1010

Discussion in 'CNC Mills/Routers' started by Armadillo Works, Feb 19, 2019.

  1. Gary Caruso

    Gary Caruso OpenBuilds Volunteer
    Staff Member Moderator Builder

    Joined:
    May 19, 2016
    Messages:
    1,193
    Likes Received:
    532
    Hi Armadillo, As long as "yellow and green" is a coil and "blue and red" is a coil you will be fine, A or B doesn't matter.
    To change the motor direction you can swap any one coil pair around for example "Y/G-B/R" to "G/Y-B/R" will turn in opposite directions.
    Keeping order consistent on a build helps for organization.
    Cheers
    Gary
     
  2. Armadillo Works

    Builder

    Joined:
    Jan 31, 2019
    Messages:
    30
    Likes Received:
    19
    Thanks! Gary.
    As with anything new it is always good to ask questions.
    By your avatar I assume you are into RC aircraft. So am I and my last building project was this Astro-Hog. Planning on using the Workbee to cut out parts.
    Roger
    P9130207.JPG
     
  3. Armadillo Works

    Builder

    Joined:
    Jan 31, 2019
    Messages:
    30
    Likes Received:
    19
    The Workbee is up and running!
    Need to make a few changes before I start making wood chips.
     
    sharmstr, GrayUK and Giarc like this.
  4. Armadillo Works

    Builder

    Joined:
    Jan 31, 2019
    Messages:
    30
    Likes Received:
    19
    P3040218.JPG

    Well the WorkBee will carve wood! Ran the Hello World test print and all went well.
    I needed to use a smaller bit but 1/4" is all I had handy.
    Thanks again to everyone who provide help.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice