X is 1000mm, Y is 1500 mm, Z is 1000mm. It Rotates 360 degrees and Tilt also can move 360 degrees. I also have a motor that controls the focus of the camera.

This is my first go at building a simple Time lapse camera rail system using as much pre-existing hardware and software as I could.

i would like to build a sturdy motorized photographic copy stand. i have hobbled together a hand crank version using a used umbrella pole but it is not suitable as it is awkward and wobbly.

A six axis camera slider with a 7th LIFT axis added!

Makerparts.ca MPro Camera Slider System

6 axis rig based on OpenBuild C-Beam and ESP32 MCU, WiFi controlled with custom app.

This system allows you to adjust the position of the microphone remotely

This is a brief overview of the build of my macro imaging slide.

My take on a non affordable slider.

I built a motion control camera slider with the V-Slot® NEMA 17 Linear Actuator Bundle (Belt Driven)

Quack Ball is a game in which the objective is to knock down moving ducks. The ducks are protected by a barricade that moves at a very fast speed. The game can be played individually or by two or more players. Each round consists of a total of ten targets to shoot and each player will have four balls to shoot. Prior to beginning play, a player selects how many ducks, maximum four, the player will knock down continuously. If player fails games is over for that player.

This is a video were take a high level look at how I built up my version of a fully open source Motorized Camera Slider (OpenSlider)

Build a manual camera slider.

I made a cam slider prototype with adjustable rotation to get experience for my CNC milled slider in planing.

DIY Pano Head

A simple 1500mm V Slot camera slider for timelapse and possibly video with an Arduino Uno controlling a Pololu A4988 driving an OpenBuilds NEMA 17 stepper, and triggering the camera.

This slider uses an 500mm OpenBuilds C-beam and the design is such that the effective length of the slider is slightly less then twice the length of the C-Beam. It can be used both motorized or not.

3d printed V-Slot Gantry Plate leveler.

feel kind of bad calling this a build because of pretty much everything is off the shelf parts. I'm writing my own sketch right now for the motion but there is a version or 2 floating around on the net based of this design. I will post my code once it's done.

A compact portable DIY camera slider for time lapse photography using a GoPro.

This is just a small project to get use to the OpenBuild products.