2 watt Laser Engraver, Simple, Fairly Low Cost, and Portable

A simple Embroidery machine using an XY belt and pinion drive to drive a hoop under a standard sewing machine. Needle timing, machine power and stepper control are all provided by a PIC processor. A tablet provides the higher level formatting required for communicating with the PIC chip.

My second attempt at an affordable sewing machine embroidery add on. This one uses readily available electronics modules and 3D printable parts where possible.

Low cost, Bluetooth enabled, 3 axis CNC controller. GRBL 0.9 compatible.

An OX CNC router using Blue OX Solutions gantry plates, a Bosch Colt router, and most of the remaining parts coming from Openbuilds parts store. Table has about 22"x55" cutting capacity and I am planning on a combination T-Slot and vacuum hold down system.

Building a Sphinx based CNC based on Kyo's plans. Going with a 1000 x 500 table size.